DaytonAudio CS620W Benutzerhandbuch - Seite 3

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Redner DaytonAudio CS620W herunter. DaytonAudio CS620W 4 Seiten. Contractor series

If the walls are made of drywall, simply cut the marked area with your utility knife. If your home has

plaster walls, then you will need to drill pilot holes at the four corners of the template outline, and cut

the speaker opening using a keyhole saw.

Check the speaker opening by placing one of the speakers into the hole. The speaker should ﬁt

loosely into the hole.

Repeat these steps for the other speaker.

5) Speaker Cable

Don't compromise sound quality by using thin, inexpensive speaker wire, we recommend using a

high quality oxygen free copper speaker cable. For runs less than 50 feet we recommend 16 gauge

cable, and for longer runs we recommend 14 gauge or larger cable. Most municipalities require the

use of CL2 rated speaker cable for installation in walls and ceilings. Leave enough speaker cable so

you can stand comfortably on the ﬂoor or ladder while connecting the speaker cable to the speakers.

Speaker Connection

Remove about 8" of the cable jacket to expose the inner conductors. Strip 1/4" of insulation from each

conductor and connect to the speaker terminals. When connecting the wires to the speakers, be sure

to observe proper polarity. Most CL2 rated speaker cable will have red and black conductors so you will

connect the red wire to the red speaker terminal and the black wire to the black speaker terminal.

7) Final Installation

To install the speakers into the wall, ﬁrst put the bottom of the mounting bracket into the cutout

so that the bracket is behind the wall. Push the top of the mounting bracket in the hole so that the

upper part of the bracket is inside the wall. Next, position the mounting bracket so that it sits in the

center of the cutout. Before tightening the screws, use a level to align the mounting bracket. Tight-

en the screws evenly in a clockwise pattern until the mounting bracket is secure. Install the speaker

and bafﬂe into the mounting bracket. Replace the grills and your installation is complete.

8) Painting Speakers

If the speaker frame is to be painted, either before or after installation, use the "Paint Masking

Template" to cover the woofer/tweeter assembly to prevent damage to them. Do not try to paint the

frame and grill assembly together. The grill should always be painted separately. Do not put such a

heavy coat of paint on the grill that the perforations are blocked.

9) Troubleshooting

Should your speakers not work properly, check the following:

No sound from speakers:

• Most stereo receivers have an A/B speaker selector switch. Make certain that this switch

is in the proper position.

• Mute feature is activated.

One speaker is playing while the other is not:

• Check the balance control on the receiver. Make sure it is centered.

• Loose connection at either the receiver or the speaker. Double check connections.

• Bad speaker cable. Replace suspect speaker wire.

Receiver cuts on and off:

• This could be caused by a short circuit between the positive and negative leads. Check

the connections at the back of the receiver, and then at the speaker. Make sure that no

strands of wire from one connector are touching the other connector.