DaytonAudio QS204-4 Benutzerhandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Redner DaytonAudio QS204-4 herunter. DaytonAudio QS204-4 5 Seiten. 70v commercial speaker pair

Seite drucken

This speaker is pre-configured from the factory for 70V/100V operation. This may cause low output when connected directly to an amplifier.

To use this speaker with a conventional (non-70V/100V) audio system, follow the below process to change the 70V/100V tap setting.

Step 1: Remove the grille

The entire grille frame should be removed by hand; tools are not necessary, though some force may be required to dislodge the grille

fasteners. Grasp the frame at a corner, and pull directly away from the speaker housing.

Step 2: Set 70V/100V Tap to 4 OHMS.

Using a screwdriver or other flat-blade tool, turn the tap selector knob until the 4 OHMS setting is selected. This will remove the

transformer from the signal path and allow a conventional amplifier to drive the speaker to full output.

Step 3: Replace Grille Frame

To reinstall the grille frame, align the pegs on the frame with the openings on the speaker enclosure, then press in firmly. Rotate the

"D" logo as required for proper orientation when installed.

NOTE: If this speaker will be used with a 70V/100V distributed audio system, do not set the 70V/100V tap to the 4 OHMS setting. Doing so

may damage your speaker when playing. The speaker is already pre-configured for use with a 70V/100V system.

If you are unsure what type of audio system you have, consult a professional installer before continuing.

Step 1

QS204

User Manual Addendum

ATTENTION

daytonaudio.com

Designed and Engineered in USA

PO Box 636, Springboro, Ohio 45066 • Phone: (937) 743-8248

QS204-4

Step 2

Last Revised: 2/25/2014