DaytonAudio QS204-4 Gebruikershandleiding - Pagina 5
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} DaytonAudio QS204-4. DaytonAudio QS204-4 5 pagina's. 70v commercial speaker pair
Pagina afdrukken
This speaker is pre-configured from the factory for 70V/100V operation. This may cause low output when connected directly to an amplifier.
To use this speaker with a conventional (non-70V/100V) audio system, follow the below process to change the 70V/100V tap setting.
Step 1: Remove the grille
The entire grille frame should be removed by hand; tools are not necessary, though some force may be required to dislodge the grille
fasteners. Grasp the frame at a corner, and pull directly away from the speaker housing.
Step 2: Set 70V/100V Tap to 4 OHMS.
Using a screwdriver or other flat-blade tool, turn the tap selector knob until the 4 OHMS setting is selected. This will remove the
transformer from the signal path and allow a conventional amplifier to drive the speaker to full output.
Step 3: Replace Grille Frame
To reinstall the grille frame, align the pegs on the frame with the openings on the speaker enclosure, then press in firmly. Rotate the
"D" logo as required for proper orientation when installed.
NOTE: If this speaker will be used with a 70V/100V distributed audio system, do not set the 70V/100V tap to the 4 OHMS setting. Doing so
may damage your speaker when playing. The speaker is already pre-configured for use with a 70V/100V system.
If you are unsure what type of audio system you have, consult a professional installer before continuing.
Step 1
QS204
User Manual Addendum
ATTENTION
daytonaudio.com
Designed and Engineered in USA
PO Box 636, Springboro, Ohio 45066 • Phone: (937) 743-8248
QS204-4
Step 2
© Dayton Audio
Last Revised: 2/25/2014
®