Dynamatic 4050 Anleitungsblatt - Seite 7

Blättern Sie online oder laden Sie pdf Anleitungsblatt für Controller Dynamatic 4050 herunter. Dynamatic 4050 14 Seiten. With dancer position
Auch für Dynamatic 4050: Anleitungsblatt (15 seiten), Anleitungsblatt (13 seiten), Anleitungsblatt (13 seiten)

Seite drucken

1. Connection Diagram for Standard Enclosure 4000 Controller

Torque Limit Modification PCB 15-444-2

Modification PCB Mounting

If you have purchased a complete controller this section may be passed over and you may proceed to

General Description.

1. Place the Main PCB in front of you with the long dimension in a horizontal position and the

terminal strip to the left.

2. Remove the DIP switch by pulling it straight out of the receptacle, RECP 1. Then, peel the adhesive-

backed label off the other half of RECP 1.

3. Insert the arrow type locking head of the four nylon stand-offs supplied into the four 0.188"

diameter holes in the main PCB and press in. The tabs will snap out to lock the stand-offs

permanently in position.

4. Hold the modification PCB assembly over the stand-offs with the ribbon connector toward you

and insert the ribbon connector plug into RECP 1. Be careful to see that all 16 pins are started

properly into the receptacle before pressing the plug in.

5. Align the holes in the modification PCB assembly over the stand-offs and press over the tapered

posts until the locking flanges snap out to lock the board in position.

General Description

For some variable speed drive application, it is necessary to limit the torque available to a machine in

order to prevent damage to the machine itself or its process. The Torque Limit modification provides an

"override" feedback signal which indirectly limits the induction motor torque (current) to a preset