Dynamic Controls DX-ACC2 Installationshandbuch - Seite 3
Blättern Sie online oder laden Sie pdf Installationshandbuch für Kontrolleinheit Dynamic Controls DX-ACC2 herunter. Dynamic Controls DX-ACC2 7 Seiten. Drive stop module
1
Introduction
The DX Drive Stop module is suitable for use in any DX system, and is used to
stop the wheelchair being driven without authorisation.
When the key is switched to the "Off" position the Drive Stop Module will
prevent the wheelchair from driving. If the key is switched to the "On" position,
the wheelchair functions normally.
Lighting and actuator functions, if fitted, operate as usual in either position.
Dynamic Controls welcomes feedback from its customers on its products
and documentation. If you would like to comment on this manual or the
product it describes, please contact us at any of the addresses at the back on
Intended Use Statement
The DX-ACC2 is an accessory of the DX System intended to prevent
unauthorised driving of a powerchair.
2
Installation
The Drive Stop Module is to be installed in a system already comprising a DX
Power Module, and DX Master Remote.
The Drive Stop should be
securely fitted in a position that is
easily accessible to the chair user.
The selected position and
orientation should also give
maximum mechanical and
environmental protection. Avoid
positions in which the module or
its wiring can be knocked or
physically damaged or those
which are exposed to splashing
and/or other forms of abuse.
this manual or by email at:
DX Drive Stop Module, March 2003
DX MASTER REMOTE
DX POWER MODULE
DRIVE STOP
MODULE
1