Dynamic Controls DX-ACC2 설치 매뉴얼 - 페이지 3

{카테고리_이름} Dynamic Controls DX-ACC2에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynamic Controls DX-ACC2 7 페이지. Drive stop module

Introduction

The DX Drive Stop module is suitable for use in any DX system, and is used to

stop the wheelchair being driven without authorisation.

When the key is switched to the "Off" position the Drive Stop Module will

prevent the wheelchair from driving. If the key is switched to the "On" position,

the wheelchair functions normally.

Lighting and actuator functions, if fitted, operate as usual in either position.

Dynamic Controls welcomes feedback from its customers on its products

and documentation. If you would like to comment on this manual or the

product it describes, please contact us at any of the addresses at the back on

Intended Use Statement

The DX-ACC2 is an accessory of the DX System intended to prevent

unauthorised driving of a powerchair.

Installation

The Drive Stop Module is to be installed in a system already comprising a DX

Power Module, and DX Master Remote.

The Drive Stop should be

securely fitted in a position that is

easily accessible to the chair user.

The selected position and

orientation should also give

maximum mechanical and

environmental protection. Avoid

positions in which the module or

its wiring can be knocked or

physically damaged or those

which are exposed to splashing

and/or other forms of abuse.

this manual or by email at:

DX Drive Stop Module, March 2003

DX MASTER REMOTE

DX POWER MODULE

DRIVE STOP

MODULE