Dynamic Controls DX-ACC2 설치 매뉴얼 - 페이지 4
{카테고리_이름} Dynamic Controls DX-ACC2에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynamic Controls DX-ACC2 7 페이지. Drive stop module
페이지 인쇄64mm
42mm
Warning: Do not use the frame of a wheelchair or scooter as the earth return for
any lights or actuators. Making any low resistance connection to the frame is
regarded as a possible safety hazard and not allowed by international performance
and safety standards for wheelchairs and scooters.
Ensure that all wiring is suitably restrained and of such a length that it is
physically impossible to connect the motor directly to the battery.
3
Safety
Users and Suppliers of Assistive Mobility products should give consideration to
the possibility of a failure to operate, or an incorrect operation, by the product.
Should an operator be left with limited or no mobility due to an equipment failure,
they should still be able to summon assistance from where ever they may be.
A warning must be conveyed to the operator that they have the responsibility to
ensure that the vehicle is kept in a good safe operating condition, and ensure that
components, such as cables, are protected from damage by securing them in
optimum positions.
All vehicle components should be regularly checked for loose, damaged or
corroded connectors, terminals, or cabling. All cables should be restrained to
protect them from damage. Damaged components should be replaced.
The user must turn the system off while getting in and out of the wheelchair.
If a wheelchair is programmed with settings other than default, under some very
rare fault conditions default settings could be automatically restored, thereby
changing driving characteristics. This in turn could lead to a chair moving in a
2
With the DX system turned off, the Drive Stop
module can be connected to any of the other DX
modules being used in the system. This will
normally be either the DX Power Module or DX
21mm
Master Remote, but can be any other module with
42mm
an available DX BUS socket.
DX Drive Stop Module, March 2003