ActivePure Induct Guardian I Handbuch - Seite 8
Blättern Sie online oder laden Sie pdf Handbuch für Kontrolleinheit ActivePure Induct Guardian I herunter. ActivePure Induct Guardian I 16 Seiten.
Seite druckenMAINTENANCE/UV LAMP INDICATOR
Your ActivePure
Induct Guardian I unit requires no periodic
®
maintenance beyond normal replacement of the ActivePure
every one (1) year.
The UV lamp operation indicator on the face of the unit will glow
when the UV lamp is in use. If the indicator does not glow and
the unit has power, the ActivePure
CHANGING THE ACTIVEPURE
• UV Light in operation; disconnect unit from power cord before servicing; failure
to follow warnings may result in severe eye damage
• Disconnect power at the breaker or fuse panel before servicing unit;
always follow OSHA lockout procedures to prevent accidental exposure to
electrical energy
WARNING
Power
Cord
1. Disconnect (unplug) power
cord from unit
NOTE: Always follow OHSA electrical lockout safety requirements to prevent accidental release of energy
during service or maintenance activities.
4. Remove the 2 thumb
screws holding the
ActivePure
Cell.
®
7. Secure with 2
thumb screws.
8
Cell should be replaced.
®
CELL
®
2. Remove the 4
thumb nuts.
5. Remove the used ActivePure
Cell from the base unit and
dispose of the bulb properly.
NOTE: Visit: www.lamprecycle.org
for proper bulb disposal regulations.
8. Insert the unit into the
mounting plate.
UV Lamp Operation Indicator
Cell
®
3. Remove the unit from
the mounting plate.
6. Plug the new ActivePure
®
Cell into the base unit. Be
sure Air Flow / Honeycomb
Cell direction is correct.
9. Secure unit with 4
thumb nuts.
®
10. Reconnect
power cord.