ActivePure Induct Guardian I 매뉴얼 - 페이지 8

{카테고리_이름} ActivePure Induct Guardian I에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ActivePure Induct Guardian I 16 페이지.

페이지 인쇄

MAINTENANCE/UV LAMP INDICATOR

Your ActivePure

Induct Guardian I unit requires no periodic

maintenance beyond normal replacement of the ActivePure

every one (1) year.

The UV lamp operation indicator on the face of the unit will glow

when the UV lamp is in use. If the indicator does not glow and

the unit has power, the ActivePure

CHANGING THE ACTIVEPURE

• UV Light in operation; disconnect unit from power cord before servicing; failure

to follow warnings may result in severe eye damage

• Disconnect power at the breaker or fuse panel before servicing unit;

always follow OSHA lockout procedures to prevent accidental exposure to

electrical energy

WARNING

Power

Cord

1. Disconnect (unplug) power

cord from unit

NOTE: Always follow OHSA electrical lockout safety requirements to prevent accidental release of energy

during service or maintenance activities.

4. Remove the 2 thumb

screws holding the

ActivePure

Cell.

7. Secure with 2

thumb screws.

Cell should be replaced.

CELL

2. Remove the 4

thumb nuts.

5. Remove the used ActivePure

Cell from the base unit and

dispose of the bulb properly.

NOTE: Visit: www.lamprecycle.org

for proper bulb disposal regulations.

8. Insert the unit into the

mounting plate.

UV Lamp Operation Indicator

Cell

3. Remove the unit from

the mounting plate.

6. Plug the new ActivePure

Cell into the base unit. Be

sure Air Flow / Honeycomb

Cell direction is correct.

9. Secure unit with 4

thumb nuts.

10. Reconnect

power cord.