ADEN POWERKIT GO Gebrauchsanweisung und Montageanleitung - Seite 7
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung und Montageanleitung für Zubehör für Fahrräder ADEN POWERKIT GO herunter. ADEN POWERKIT GO 16 Seiten.
Seite druckenPOWERKIT GO — ASSEMBLY INSTRUCTIONS
ADEN GmbH
ASSEMBLY
Install rear wheel and belt. The belt is "temporarily" fixed
anywhere on the frame.
Make sure that the wheel can be turned easily and that no
brake cable or anything else is rubbing against the belt ring.
Assembly-Note:
Make sure that the belt is not damaged when turning the rear
wheel.
A cable tie is used to finally center the belt ring attached to the
swing arm, place it on the ring and check the concentricity of the
ring.
Assembly-Note:
Alternatively, the "belt ring ALIGNMENT TOOL" was used
beforehand
The belt ring is brought into the correct position by pressing or
lightly tapping it with a blunt object. Check concentricity again
and again by turning the wheel.
Repeat the process until centering is as precise as possible.
(less than 0.5 mm is sufficient)
Carefully tighten the outer screws to prevent them from slipping
to avoid the ring. Then screw in the remaining screws and tighten
the T-key with 2 fingers (max. 1.5 Nm). Check all screws again.
Assembly-Note:
Tighten the outer screws carefully to prevent the ring from
slipping.
www.aden-sports.com
EN | P. 7