ADEN POWERKIT GO 사용 설명서 및 조립 설명서 - 페이지 7

{카테고리_이름} ADEN POWERKIT GO에 대한 사용 설명서 및 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ADEN POWERKIT GO 16 페이지.

POWERKIT GO — ASSEMBLY INSTRUCTIONS

ADEN GmbH

ASSEMBLY

Install rear wheel and belt. The belt is "temporarily" fixed

anywhere on the frame.

Make sure that the wheel can be turned easily and that no

brake cable or anything else is rubbing against the belt ring.

Assembly-Note:

Make sure that the belt is not damaged when turning the rear

wheel.

A cable tie is used to finally center the belt ring attached to the

swing arm, place it on the ring and check the concentricity of the

ring.

Assembly-Note:

Alternatively, the "belt ring ALIGNMENT TOOL" was used

beforehand

The belt ring is brought into the correct position by pressing or

lightly tapping it with a blunt object. Check concentricity again

and again by turning the wheel.

Repeat the process until centering is as precise as possible.

(less than 0.5 mm is sufficient)

Carefully tighten the outer screws to prevent them from slipping

to avoid the ring. Then screw in the remaining screws and tighten

the T-key with 2 fingers (max. 1.5 Nm). Check all screws again.

Assembly-Note:

Tighten the outer screws carefully to prevent the ring from

slipping.

www.aden-sports.com

EN | P. 7