DBK DBK33 Schnellstart-Handbuch - Seite 3
Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Stromversorgung DBK DBK33 herunter. DBK DBK33 4 Seiten. Triple-output power supply card
Seite druckenConnecting the DBK33
The DBK33 can be installed into the internal expansion slot of a DaqBook/112, DaqBook/216,
DaqBook/2000X, a 3-Slot DBK10, a 3-slot DBK60, or a 10-Slot DBK41. It can also be used in a
LogBook/360 and DaqBook/260.
If you will be using a 3-port DaqBook, i.e., DaqBook/100, /120, /200, /260, or /2000 Series with
a DBK41, then the best location for the DBK33 is the right-hand end-slot of the DBK41 when
facing the DBK41's rear panel. This will be the left-hand slot if facing the DBK41 from the
front-panel.
DBK33's P1 Connector
DBK33's DB37 P1 connector interfaces with the analog DBK in one of two ways:
a) Via a backplane, such as in the case of installing the DBK33 in a DBK41. For products with P1
b) Via a CA-37-x cable, which interfaces between the DBK33's P1 connector and the P1
DBK33's DIN5 Connectors
The DBK33 can be powered from a 9 to 18 VDC source such as an AC/DC power adapter, a DBK30A
battery module, or a car battery.
The DBK33 has two DIN5 power connectors to allow for the cascading of multiple DBK33s
(via a CA-115 power cable). The lower right-hand section of the preceding figure portrays this scenario.
Note that a DBK33 can share a power source with an acquisition device. For example, you can connect a
CA-115 power cable to the DIN5 Power Out connector of a DaqBook, DaqBoard, or LogBook and then
connect the other end of the CA-115 cable to one of the DIN5 connectors on the DBK33.
DBK Option Cards and Modules
Examples of DBK33 Connections
backplanes, if you will be installing a DBK33 internally, you must have the correct configuration
of a backplane jumper(s) to disconnect the device's +5 VDC from the backplane. Refer to the
device's primary documentation in regard to the configuration.
connector(s) of the analog DBK(s) that it is to supply power to.
879795
DBK33, pg. 3