Galaxy DX95T2 Benutzerhandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Sende- und Empfangsgerät Galaxy DX95T2 herunter. Galaxy DX95T2 9 Seiten. 10 meter amateur mobile transceiver with built-in frequency counter & starlite face plate

Seite drucken

CHAPTER 2 INSTALLATION

INSTALLING THE RADIO

Choose a convenient location for operation that does not interfere with driver or

passenger. This radio is supplied with a universal mounting bracket. When

mounting the bracket and radio to your car, make sure it is mechanically strong.

Also, provide a good electrical grounding connection to the chassis of vehicle.

Proceed as follows to install the radio.

1. Locate a convenient area in your vehicle for the installation of the radio. Hold

the mounting bracket with the radio in the location where the radio is to be

installed. Make sure nothing will interfere with either the radio or the

mounting bolts. Mark and then drill holes for the mounting bracket.

2. Most radio antennas come equipped with a PL-259 plug. Connect this plug to

the ANT. Jack in the rear of the radio.

3. Extending from the rear of the radio is a fused red and black wire for the DC

connections to the vehicle's electrical

strongly recommended that the red lead be taken directly to the positive

terminal on the vehicle's

chassis ground. (Note: This radio is designed for vehicles with negative

ground systems.)

Connections should be made using appropriate "c

enough to make good contact with the bolt used to fasten to the battery and the

chassis ground. It is a good safety id ea to install a second fuse that would

provide protection in case the red wire was to"f

to the body of the vehicle, somewhere between the battery and the radio.

High power radios such as this one require large DC current flow when in the

TX mode. Poor power connections cause supply voltage drops that can

substantially decrease the performance of your radio. A good DC connection is

probably one of the most important things for getting the best transmitter

performance and in some cases, least receiver noise.

4. Mount the microphone bracket near the radio in an easily accessible spot using

the two screws provided.

system. For best performance, it is

bat

tery and the

black lead be connected to the nearest

ray"

rim

p on"plugs of a size large

or get pinched and short