909 LT18V Gebrauchsanweisung - Seite 13

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Trimmer 909 LT18V herunter. 909 LT18V 20 Seiten. 20v lithium ion cordless line trimmer

Seite drucken

Important information - product care

This line trimmer uses Lithium-Ion battery cells. Care
MUST be taken to ensure both the safety and life of the
pack is maintained. Ensure you have read all of the safety
notes in the previous pages before using the line trimmer.
Safety devices and circuitry for this tool are located in
the battery pack of this tool. The battery pack is a vital
component, not just for the power source, but also for
the full safety control for both the charging and also the
tool operation. Treat the battery pack with care and within
the guidelines of this manual. If the pack does become
immersed in water or any fluids, or is subject to a severe
drop etc, or it does not operate within the guidelines of
this manual, immediately STOP using the battery pack
and have it checked.
During operation, avoid overloading the tool. If the tool is
overloaded it will automatically STOP. Overloading may
occur for a number of reasons including when the tool
is pushed too hard. If you do overload the tool during
operation refer to the "Overload" section in this manual.
Note:
When the battery of the tool is at the lower end of the
charge, the tool is more susceptible to the overload condition.
As mentioned above, the battery pack is an integral
component of this tool and is fitted with thermal safety
devices. Running the tool at close to maximum load, or
continual resetting of the overload will cause the battery
pack to over heat. When a preset cell temperature is
detected, the battery pack will automatically STOP
operating and will not restart until the battery pack has
cooled to a safe level.
In this condition, DO NOT force-cool the pack by placing in
a freezer or similar device. Refer to the "Overload" section
in this manual.
Another feature of the battery pack is the low voltage
cut out feature. This feature operates when the voltage
drops below a preset value. When this occurs the tool
will automatically stop operating. To correct the situation
you need to either insert another charged battery into the
trimmer or recharge the existing battery, and then proceed
with the application.
Note:
Attempting to restart the tool in this condition without
either recharging the battery or installing a battery with
charge will lead to it restarting and then stopping again after
only a few seconds of operation.
These safety devices have been fitted for the safety,
reliability and life of the tool.
13