DynaQuip WaterCop WROPE6 Benutzerhandbuch und Installationshandbuch - Seite 9

Blättern Sie online oder laden Sie pdf Benutzerhandbuch und Installationshandbuch für Kontrollsysteme DynaQuip WaterCop WROPE6 herunter. DynaQuip WaterCop WROPE6 16 Seiten.

DynaQuip WaterCop WROPE6 Benutzerhandbuch und Installationshandbuch

Wireless WPM Hub Sensor and Accessories

Onboard Temperature
WPM: This is what is considered the "Hub" . It
Sensor – Trip Point 45°F
requires AAA Alkaline batteries (or the optional AC
Adapter) and wirelessly communicates with the Pro
Control Panel . Sensor probes and other accessories
are attached to the Hub in many different
configurations . Ambient temperature sensing is on-
board . If a temperature of 45°F or below is detected,
it will send a signal to the Control Panel .
WPSC: These are the same leak probes with 10'
of cable currently used for Pro . They wire into the
screw terminals that are accessed on the bottom of
the WPM . They have a unique hexagon shape and
they are what make single and dual leak sensors .
You can have 1 or 2 of the leak probes on each
WPM .
Standard Pro Sensor (WPSC)
Power Supply
Connection
Learn
Button
Water Probe
10'
Connection
Aux
Water Probe
Connection
Connection
WROPE6: This wireless sensor
accessory has a male plug that
6'
inserts into the female AUX jack
Rope Sensor (WROPE6)
in the Hub . It's 6' long and can be
shortened as needed . The leak
sensing is all along the braided
cord and comes with 20 clips to
secure to the floor or surface using
the included double-sided tape or screws .
WPRS095: This wireless sensor accessory will
detect high pressures and is factory set to trip
at 95 psi . It's field adjustable to trip from 50 to
120 psi . This has a male plug that inserts into
Pressure Switch (WPRS095)
the same female AUX jack on the bottom of the
Factory Set at 95 psi
WPM . To use both pressure and rope sensors,
Field Adjustable
use the WSPLIT described just below .
WSPLIT: This wireless sensor accessory will
allow an Installer to use both a rope and
Splitter (WSPLIT)
pressure, or two rope sensors, from one
WPM . It has a male plug that inserts into the
AUX jack on the bottom of the WPM and
it branches off to 2 female jacks . It's only a
few inches long .
9