Autonomic MMS 5A Setup-Handbuch - Seite 10

Blättern Sie online oder laden Sie pdf Setup-Handbuch für Server Autonomic MMS 5A herunter. Autonomic MMS 5A 17 Seiten. Mirage media server

Seite drucken

Audio Settings

The

tab allows you to configure audio settings and system outputs on the MMS.

Source Settings

The

Audio System

section allows you to configure the MMS for RS-232 or IP connection to an

external multi-room amplifier.

The

section allows you to enable or disable each output, rename them, configure

Connections

maximum sampling rate and bit depth (digital outputs only) and set each to variable or fixed

gain output for pass-through control of volume, mute and zone power on the amp from the

MMS OSD and web interface.

Fixed vs. Variable Gain

Fixed Gain is recommended in when the connected amplifier has an accessible volume control.

NOTE

Failing to set the output to fixed in this circumstance can cause contention between the MMS

volume control and the amplifiers volume control and can affect sound quality.

Variable gain should be used if the MMS is connected to an amplifier that does not have a

volume control, or if you wish to control the volume of the MMS directly with the Mirage web

interface or mobile applications.

Disabling Unused Outputs

If you will not be using all of the available outputs, set the option to

those outputs from consuming system and power resources, and will remove these items from

the lists.

Renaming Outputs

You can rename the source outputs by double clicking on their name in the web browser. The

new name will be used on our web control interface and mobile applications.

For control system integrations, the server will always respond correctly to commands issued

using the default output names, and will also respond commands issued using the new names.

For this reason, you should avoid renaming the outputs to any of the other default names (ie,

Main, Player_A, etc.)

Bit Depth And Sample Rate Resolution

You can set the bit depth and sample rate of the digital audio outputs to values from 16-bit/44

kHz, all the way up to 24-bit/192 kHz on the MMS·5A and 24-bit/96kHz on the MMS·2.

You should set this value to the highest setting that your amplifier or AV receiver can support. If

you're unsure of the highest supported bit depth and sample rate on your equipment, the MMS

will play a sample sound in each speaker whenever you change this setting. If you hear the test

tone, your amplifier supports that setting. If you do not hear a test tone, lower this setting until

you can hear the test signal.

Using AirPlay

The

section allows you to assign one output on the MMS to be an AirPlay

AirPlay Receiver

receiver. When enabled, the Mirage Media Server will be displayed on the AirPlay menu of any

device or software that supports airplay (iOS devices and iTunes running on a Mac or PC).

When the Mirage Media Server is selected, any currently playing content will be interrupted

and the server will begin to wirelessly stream the content from the connected device.

9 of 16

. This will keep

Disabled

Mirage Media Server Set Up