Galeski Polifox 1300 Betriebsanleitung - Seite 6

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Sander Galeski Polifox 1300 herunter. Galeski Polifox 1300 9 Seiten.

Seite drucken

ENGLISH • Operating Instructions POLIFOX

3. Before Operation

3.1 Mounting of Tools

Lock the work spindle (3) by depressing the

spindle lock (1). (Refer to picture at chapter

no. 13.)

Attention! Use spindle lock only when

working spindle is not in operation!

Mount tool and tighten with appropriate

spanner.

4. Switching on and off

Switching on: Push the red switch forward

and upward.

Switching off: To unlock, press the grey

part of the switch upward. The switch will

automatically move back to "0".

5. Electronic Device

The speed of rotation is adjusted electroni-

cally when the load increases.

In case of a longer overload period the

speed is decreased electronically. The ma-

chine continues to run slowly to cool down

the motor coil. After switching off and on, the

machine can be used at rated load.

The duration of cooling-down period

depends on the grade of overload.

Under the effect of extreme electro-magnetic

interferences from the outside, temporary

variations in the speed of rotation could arise

in particular cases.

6. Smooth Start

The electronic smooth start feature

prolonges the life of both motor and gear,

power input at start-up is reduced by approx-

imately half.

7. Accessories

Please refer to our catalogue for a range of

accessories along with order-numbers.

8. Service

Keep the machine and the ventilation slots

clean.

Use only GALESKI accessories and spare

parts. Should components need to be ex-

changed which have not been described,

please contact GALESKI company.

If needed, a listing of the machine parts with

picture can be requested from GALESKI

company. Please indicate machine type and

serial-number found on rating label of ma-

chine.

9. Using the Machines

Carefully consider information given by tool-

manufacturer as to proper tool-speed. (If you

work with Polifox Vario 1500, adjust machine

to the correct speed. See chapter 12 for

speed values.)

We do not accept liability for any damage

caused by operating tools with improper

speed.

Never use machine for any dry grinding

or polishing! (The sealing rings need wa-

ter for cooling.)

Handling:

• Mount the appropriate tool to the working

spindle and tighten with spanner.

• Open water control valve until there is an

ample, continuous water supply. Use water

moderately.

• Switch on machine.

• When working with diamond-armed drill

bits, position machine level with the work-

piece, drill slowly but steadily, do not cant.

• Never use without water! Remove drill bit

from workpiece while turning.

• When grinding do not apply pressure on

tool but use it with gentle reciprocating

movements.

• Make sure, that during work machine re-

mains as dry as possible. For that purpose

the workpiece could be tilted at an angle by

resting the closest flank on a supporting tim-

ber.

• Sintered diamond tools can be sharpened

with a sharpening stone. Never sharpen gal-

vanic-plated (electro-plated) tools!

• After finishing work: it is important to

clean the machine and dry it by using

some compressed air.

10. CE-Declaration of Conformity

We declare under our sole responsibility that

this product is in conformity with the follow-

ing standards or standardization documents:

EN 50 144, EN 55 104, EN 55 014, EN 60

555, HD 400, according to the provisions of

the regulations 73/23/EEC, 89/336/EEC,

89/392/EEC.

– 6 –

GALESKI WERKZEUGE