Galeski Polifox 1300 Manuale di istruzioni per l'uso - Pagina 6
Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Sander Galeski Polifox 1300. Galeski Polifox 1300 9.
Stampa la paginaENGLISH • Operating Instructions POLIFOX
3. Before Operation
3.1 Mounting of Tools
Lock the work spindle (3) by depressing the
spindle lock (1). (Refer to picture at chapter
no. 13.)
Attention! Use spindle lock only when
working spindle is not in operation!
Mount tool and tighten with appropriate
spanner.
4. Switching on and off
Switching on: Push the red switch forward
and upward.
Switching off: To unlock, press the grey
part of the switch upward. The switch will
automatically move back to "0".
5. Electronic Device
The speed of rotation is adjusted electroni-
cally when the load increases.
In case of a longer overload period the
speed is decreased electronically. The ma-
chine continues to run slowly to cool down
the motor coil. After switching off and on, the
machine can be used at rated load.
The duration of cooling-down period
depends on the grade of overload.
Under the effect of extreme electro-magnetic
interferences from the outside, temporary
variations in the speed of rotation could arise
in particular cases.
6. Smooth Start
The electronic smooth start feature
prolonges the life of both motor and gear,
power input at start-up is reduced by approx-
imately half.
7. Accessories
Please refer to our catalogue for a range of
accessories along with order-numbers.
8. Service
Keep the machine and the ventilation slots
clean.
Use only GALESKI accessories and spare
parts. Should components need to be ex-
changed which have not been described,
please contact GALESKI company.
If needed, a listing of the machine parts with
picture can be requested from GALESKI
company. Please indicate machine type and
serial-number found on rating label of ma-
chine.
9. Using the Machines
Carefully consider information given by tool-
manufacturer as to proper tool-speed. (If you
work with Polifox Vario 1500, adjust machine
to the correct speed. See chapter 12 for
speed values.)
We do not accept liability for any damage
caused by operating tools with improper
speed.
Never use machine for any dry grinding
or polishing! (The sealing rings need wa-
ter for cooling.)
Handling:
• Mount the appropriate tool to the working
spindle and tighten with spanner.
• Open water control valve until there is an
ample, continuous water supply. Use water
moderately.
• Switch on machine.
• When working with diamond-armed drill
bits, position machine level with the work-
piece, drill slowly but steadily, do not cant.
• Never use without water! Remove drill bit
from workpiece while turning.
• When grinding do not apply pressure on
tool but use it with gentle reciprocating
movements.
• Make sure, that during work machine re-
mains as dry as possible. For that purpose
the workpiece could be tilted at an angle by
resting the closest flank on a supporting tim-
ber.
• Sintered diamond tools can be sharpened
with a sharpening stone. Never sharpen gal-
vanic-plated (electro-plated) tools!
• After finishing work: it is important to
clean the machine and dry it by using
some compressed air.
10. CE-Declaration of Conformity
We declare under our sole responsibility that
this product is in conformity with the follow-
ing standards or standardization documents:
EN 50 144, EN 55 104, EN 55 014, EN 60
555, HD 400, according to the provisions of
the regulations 73/23/EEC, 89/336/EEC,
89/392/EEC.
– 6 –
GALESKI WERKZEUGE