Galvin Engineering Haws SP220SS Produkt-Installations-Manualline - Seite 3

Blättern Sie online oder laden Sie pdf Produkt-Installations-Manualline für Sanitärprodukt Galvin Engineering Haws SP220SS herunter. Galvin Engineering Haws SP220SS 7 Seiten. Pedestal floor mtd, axion msr eye/face wash head, s/s bowl, hand & foot act
Auch für Galvin Engineering Haws SP220SS: Produkt-Installations-Manualline (7 seiten)

Seite drucken

INSTALLATION PROCEDURE

Refer to Installation Drawing for clarification. Check parts list to ensure all required

parts are included. Use an AS 4020 approved pipe joint sealant on all connections.

STEP 1: Prepare the emergency shower foundation by using the floor flange as a

template. Locate the three holes for the 3/8-16 UNC x 6" anchor bolts.

(Not supplied). They should extend 1" above the floor level.

STEP 2: Once the concrete foundation is ready (dry), assemble the floor flange to

the anchor bolts; then securely fasten with 3/8-16 UNC Hex nuts and 3/8"

washers (Not supplied). Seal and tighten floor flange and (1-1/4") tee

making certain the waste tee is facing the proper location and the foot

control holes are facing side to side.

STEP 3: Assemble nipple (1-1/4" x 24") to the tee and tighten with a pipe wrench.

STEP 4: Assemble the eye/face wash loop assembly to the (24") nipple from Step

three. Connect the pipe wrench to the nipple between the two tees to

avoid damage.

STEP 5: Assemble in the following order:

Attach nipple (1-1/4" x 24") onto the loop assembly.

Attach nipple (1-1/4" x 24") onto the tee.

Attach tee (1-1/4" x 1-1/4" x 1") onto nipple.

Attach nipple (1" x 8") and valve assembly onto tee.

Attach street elbow (1") and nipple (1" x 12-1/2") onto valve.

STEP 6: Assemble showerhead onto street elbow (1").

STEP 7: Assemble the sign onto the unit. Use the strap, screws, washers and

nuts provided to mount the sign onto the upright. The sign should be

positioned for maximum visibility.

STEP 8: Insert the plug into the optional supply line tee that is not used. Before

connecting the supply water line to the emergency shower; CHECK IF

THE ASSEMBLY IS RIGIDLY TIGHTENED AND FLUSH THE LINE

THOROUGHLY.

Version 3.1, 13

Aug. 2021, Page 3 of 7