AGS Parksafe Control Panel Handbuch für Installation, Betrieb und Wartung - Seite 15

Blättern Sie online oder laden Sie pdf Handbuch für Installation, Betrieb und Wartung für Controller AGS Parksafe Control Panel herunter. AGS Parksafe Control Panel 20 Seiten. Ventilation control panel
Auch für AGS Parksafe Control Panel: Handbuch für Installation und Betrieb (16 seiten), Handbuch für Installation und Betrieb (16 seiten), Installation, Betrieb und Wartung (16 seiten)

Installation, Operation & Maintenance

Step 2. Test Detector

Access to the interior of the detector, when carrying out any work, must be conducted by a competent person!

Apply a gas concentration ~50% higher than the alarm setpoint but do not exceed the upper limit of measurement!

Ensure you have the correct calibration gas for the device type.

•

If using a cylinder - screw the regulator/valve into the gas cylinder outlet.

•

Offer up the applicator hose/cone and fully cover the sensing element on the front case.

•

Open the valve/regulator to allow the gas to be delivered at a pre-set flow rate.

•

Apply gas to the gas inlet holes on the front of the detector housing.

•

The detector 'Alarm' LED will illuminate at the alarm set point.

•

The Controller will activate all configured outputs/relays (unless service mode is activated) and will display the gas

•

concentration detected.

Remove applicator hose/ cone and turn the gas cylinder regulator/valve off.

•

Wait for detector to stabilise / return to normal.

•

Reset the service reminder by tapping the circuit test button 3 times (within 2 seconds)

•

Test complete.

•

Record your test details.

•

Rev: 20

ParkSafe Controller