HIKE CREW HICPSBT Benutzerhandbuch - Seite 7

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Warmwasserbereiter HIKE CREW HICPSBT herunter. HIKE CREW HICPSBT 15 Seiten.

OPERATIONAL MODES

This unit can operate in three different modes.

Battery mode - runs the unit on battery power without any additional power supply. To run in battery

mode, be sure to first charge the battery.

Charging mode - runs the unit via the AC/DC power adapter (attachment #4). While operating in

charging mode, the battery will charge while the unit is in use.

Direct power mode - runs the unit via the 12 V DC power adapter (attachment #5). While

operating in direct power mode, the battery will not charge.

INITIAL SET UP

1. Remove all components from the storage bag and place the appliance

on a solid, non-combustible surface. Straighten out all hoses and remove

any kinks or twists.

2. Screw the gas regulator (attachment #1) in a clockwise direction onto

the gas inlet (connection point #1) on the back of the device and

secure tightly.

Note: Check that the black rubber seal has been fitted onto the gas inlet

pipe before connecting the gas regulator (attachment #1).

3. Screw the propane tank onto the gas regulator (attachment #1) and

tighten securely. Check for leaks with soapy water (not a flame). If a

leak is detected, remove the propane tank, retighten all connections,

and test again.

4. With the power switch set to the "off" position, plug the pump power connecter

(attachment #2.5) into pump DC power input (connection point #5).

5. Connect the pump hose (attachment #2) to the water inlet

(connection point #2).