HIKE CREW HICPSBT 사용자 설명서 - 페이지 7

{카테고리_이름} HIKE CREW HICPSBT에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKE CREW HICPSBT 15 페이지.

OPERATIONAL MODES

This unit can operate in three different modes.

Battery mode - runs the unit on battery power without any additional power supply. To run in battery

mode, be sure to first charge the battery.

Charging mode - runs the unit via the AC/DC power adapter (attachment #4). While operating in

charging mode, the battery will charge while the unit is in use.

Direct power mode - runs the unit via the 12 V DC power adapter (attachment #5). While

operating in direct power mode, the battery will not charge.

INITIAL SET UP

1. Remove all components from the storage bag and place the appliance

on a solid, non-combustible surface. Straighten out all hoses and remove

any kinks or twists.

2. Screw the gas regulator (attachment #1) in a clockwise direction onto

the gas inlet (connection point #1) on the back of the device and

secure tightly.

Note: Check that the black rubber seal has been fitted onto the gas inlet

pipe before connecting the gas regulator (attachment #1).

3. Screw the propane tank onto the gas regulator (attachment #1) and

tighten securely. Check for leaks with soapy water (not a flame). If a

leak is detected, remove the propane tank, retighten all connections,

and test again.

4. With the power switch set to the "off" position, plug the pump power connecter

(attachment #2.5) into pump DC power input (connection point #5).

5. Connect the pump hose (attachment #2) to the water inlet

(connection point #2).