Gama Garden GT-35 Gebrauchsanweisung - Seite 3
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Pinne Gama Garden GT-35 herunter. Gama Garden GT-35 14 Seiten. Petrol powered cultivator
Seite druckenPrincipal safety engineering rules for the work
performance
This chapter describes the principal safety engineering rules
of work performance with the cultivator. The warnings
concerning the users' safety and structural characteristics of
the cultivator are included in the relevant chapters of the
instruction manual.
Prior to use of cultivator
The cultivator must not be used by persons who are under the
influence of alcohol, drug or medicine.
Persons below 16 years of age must not use the cultivator.
Make sure that all unauthorised persons, including children
and domestic animals, are staying outside the efficient range
of the cultivator.
During work performance with the cultivator
During work performance, wear protective clothing, secure
footgear, goggles and gloves.
Do not refill the cultivator fuel tank while operating. Petrol may
be refilled only outdoors.
Perform the work far away from open flames and sparks and
avoid smoking.
Do not touch the rotary blades of the cultivator by your hand,
foot or even your clothing. The cultivator motor, exhaust
silencer and reducer will warm up during the work
performance and cool down continually.
The engine can be stopped in the following cases:
When the work performance with the cultivator is
finished;
During maintenance and adjustment operations;
When the cultivator is relocated from a working site to
another
Store the cultivator and the petrol in a place unreachable for
children and at a safe distance from sparks, fire and radiators.
Prior to locating the cultivator in a closed room for permanent
storage, wait for the motor to cool down entirely. The parts
must be in compliance with the manufacturer's specifications.
Use only original parts.
The cultivator may be repaired only by an authorised service
repair shop.
Safety engineering devices
Clutch lever
When the clutch lever is released, the cultivator rotary blades
will stop.
Do not change or block the operation of the clutch lever in any
way.
Guard
It will protect the user from injuries caused by pieces of soil
flying out from under the cultivator rotary blades.
The guard must always be in a condition ready for service.
Handlebar cross-tube
It will ensure the distance between the user and the cultivator
rotary blades.
Information on the cultivator
For ensuring safe operation and maintenance of the
cultivator, each symbol can be seen on the device in the form
of die stamped or projected picture.
Place of fuel refilling.
Location: on the fuel tank cover.
Indication of engine of top valve arrangement.
Location: on the cover of the valve mechanism.
OHV
ATTENTION: Hot surface!
Location: on the cover of the exhaust silencer.
START
Location: on the handle of the pull cord.
Air valve handle bar
CHOKE
Positions:
RUN
1. CHOKE – fully closed.
2. RUN – fully open.
Location: on the air filter cover.
Fuel metering valve.
ON/OFF
Positions:
1. ON – open. 2. OFF – closed.
Location: on the motor case.
Starter switch. Positions:
ON/OFF
1. ON – switched on. 2. OFF – switched off.
Location: on the motor case.
Stickers showing the operations done by the
controls
Control of the rotation of the rotary blades
When the handle of the rotary blade is pressed,
the cultivator rotary blades start to rotate.
Location: on the handle driving the rotary blades.
Warning symbols
There is a sticker containing warning symbols on the
cultivator guard. Prior to starting the operation, get
acquainted with these warnings and apply them during your
work.
Prior to starting to use the cultivator, read
the instruction manual, but mainly the
section "For your safety".
Risk of injury by the rotary blades -
Keep your hand and feet away at a safe
distance from the rotary blades.
Risk of injury or risk of damaging the objects
found
nearby.
unauthorised persons, including children and
domestic animals are staying out of the
efficiency range of the cultivator.
DO NOT WORK WITHOUT THE GUARD
BEING INSTALLED. Prior to performing the
cultivator maintenance, remove the cap of
the high voltage line from the spark-plug of
the motor.
Make
sure
that
all
3