AgSense AQUA-TRAC Lite Verdrahtungshinweise - Seite 4

Blättern Sie online oder laden Sie pdf Verdrahtungshinweise für Messgeräte AgSense AQUA-TRAC Lite herunter. AgSense AQUA-TRAC Lite 20 Seiten. 2015-18 soil moisture monitoring

Seite drucken

General Overview of the Aqua Trac Lite

Note 1: Once all sensors are connected and unit is ready to run, you must turn the ON/OFF

switch to the "ON" position, and go to the AgSense User page to finish setup and configuration

of this unit to read the sensors that you have installed.

Note 2: The pins marked SENSOR POWER as shown above should have a jumper connecting

the middle and 5v pins. This selects the power output to the sensors to be 5v. Do not move this

jumper for any reason unless these instructions inform you to do so. Never Remove this jumper

with the power switch turned on – turn the power switch off first or the attached sensors can be

damaged.

Note 3: Only use the charging adapter supplied from AgSense to prevent damage to this unit.

Batteries can take up to 48 hours to fully charge – please check the battery voltage to make sure

they are fully charged (4.2v) at the "Batt 4.2v" hole right by the battery plug in.

Page 1