AgSense AQUA-TRAC Lite Instrucciones de cableado - Página 4
Navegue en línea o descargue pdf Instrucciones de cableado para Instrumentos de medida AgSense AQUA-TRAC Lite. AgSense AQUA-TRAC Lite 20 páginas. 2015-18 soil moisture monitoring
Imprimir páginaGeneral Overview of the Aqua Trac Lite
Note 1: Once all sensors are connected and unit is ready to run, you must turn the ON/OFF
switch to the "ON" position, and go to the AgSense User page to finish setup and configuration
of this unit to read the sensors that you have installed.
Note 2: The pins marked SENSOR POWER as shown above should have a jumper connecting
the middle and 5v pins. This selects the power output to the sensors to be 5v. Do not move this
jumper for any reason unless these instructions inform you to do so. Never Remove this jumper
with the power switch turned on – turn the power switch off first or the attached sensors can be
damaged.
Note 3: Only use the charging adapter supplied from AgSense to prevent damage to this unit.
Batteries can take up to 48 hours to fully charge – please check the battery voltage to make sure
they are fully charged (4.2v) at the "Batt 4.2v" hole right by the battery plug in.
Page 1