Dea SWINGER Betriebsanleitung - Seite 10

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Toröffner Dea SWINGER herunter. Dea SWINGER 20 Seiten. Electro-mechanical operator for swing gates
Auch für Dea SWINGER: Betriebsanleitung und Warnhinweise (13 seiten)

Seite drucken

1. Installation and Assembly

7 ADVANCED PROGRAMMING

Here are some added programming procedures relating to remotes memory management and advanced configuration of the control

inputs.

1 Deletion of memorized transmitters

1.1 Deletion of all transmitters

1. Scroll down the parameters until you visualize P004;

2. Confirm by pressing on the

3. When "

" is flashing, press the

onds;

4. Release the

key as soon as "

5. All memorized transmitters have been deleted (display

shows again P004).

1.2 How to search and delete a transmitter

1. Scroll down the parameters until you visualize P006;

2. Confirm by pressing on the

3. By pressing on

want to delete (eg.

4. When "

" flashes, confirm the deletion by pressing

the

key for a few seconds;

5. Release the

key when appears "

6. The selected transmitter is deleted (display shows again

P006).

2 Resetting of default parameters

1. Scroll down the parameters until you visualize P007;

2. Confirm by pressing on the

3. When "

" flashes, press the

4. Release the

key as soon as "

Default parameters for the configuration currently in

use are restored;

5. At the end of the operation display returns to P007.

Warning: After you restore the default parameters, you

must program the control panel again and adjust all ope-

rating parameters, in particular, remember to properly set

the configuration of parameters (P028 - P029 - P030 –

operator configuration).

3 Locking-Unlocking access to programming

By using a "dip-switch" remote (regardless of the type of remotes already memorized) it's possible to lock-unlock access to the program-

ming of the control panel to avoid tampering. The remote setting is the locking-unlocking code verified by the control board.

3.1 Locking access to programming

1. Scroll through the parameters with the buttons

and

until the display shows P008;

2. Access the parameter by pressing the button

3. The display shows alternately the writing

to indicate that the control board

is waiting for the transmission of the block code;

4. Within 10 seconds press CH1 on the "TX Master",

the display shows

to the list of parameters;

5. Access to programming is locked.

key;

key for a few sec-

" stops flashing;

key;

and

, keys, select the transmitter you

);

key;

" stops flashing;

;

before returning