GAME SandPRO 35D Benutzerhandbuch - Seite 15
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Water Filtration Systems GAME SandPRO 35D herunter. GAME SandPRO 35D 20 Seiten. Pool filter system
Seite drucken
- 1. Table of Contents
- 2. Safety Warnings
- 3. General Information
- 4. Technical Specifications
- 5. Parts List/Reference
- 6. Getting Started
- 7. Assembly Instructions
- 8. Connecting the Filter System
- 9. Valve Operations
- 10. Filter Operations
- 11. Maintenance
- 12. Troubleshooting
- 13. Limited Warranty Statement
- 14. Appendix: Exploded Parts Diagram
11. TROUBLESHOOTING
Problem
Cause
Pressure is too
Hair and lint strainer basket is dirty
low
Air in the pump
Poor seal on the intake side of the pump
Water flows into
Dirt around the seal of the 4 way valve
the drainpipe
Leaking filter
Faulty Seal
Clamp not tight
Pump does not
Not plugged in
run
GFCI/or main circuit breaker tripped
Faulty Pump Motor
Sand in pool
If the sand is newly replaced, the undersized
grains are still present
Sand in central valve (from backwash)
Filter's bottom strainer is damaged
Air in system
Water level is low or system recently opened
for service
REPAIRS ON THE PUMP SHOULD ONLY BE PERFORMED
BY PROFESSIONALLY TRAINED, QUALIFIED TECHNICIANS.
Solution
Clean the hair and lint strainer.
Tighten hose clamps and connection fittings.
Remove the 4 way valve from tank and clean the seal.
Check the seal, replace if needed.
Tighten clamp. DO NOT overtighten hose clamps
(35 in/lb max torque).
Check the socket and power cord.
Switch on the breaker. If it is immediately tripped again,
there is a defect in pump or controls.
Replace the pump/motor assembly.
Backwash several times until the backwash water is clear.
Purge into drainpipe for 30 seconds.
Replace the filter bottom strainer.
While pump is running, loosen, but do not remove, the pressure
gauge or pressure gauge plug to release air. Then retighten the
gauge or plug.
15
SAVE THESE INSTRUCTIONS