GAME SandPRO 35D Manual del usuario - Página 15

Navegue en línea o descargue pdf Manual del usuario para Sistemas de filtración de agua GAME SandPRO 35D. GAME SandPRO 35D 20 páginas. Pool filter system

Imprimir página

11. TROUBLESHOOTING

Problem

Cause

Pressure is too

Hair and lint strainer basket is dirty

low

Air in the pump

Poor seal on the intake side of the pump

Water flows into

Dirt around the seal of the 4 way valve

the drainpipe

Leaking filter

Faulty Seal

Clamp not tight

Pump does not

Not plugged in

run

GFCI/or main circuit breaker tripped

Faulty Pump Motor

Sand in pool

If the sand is newly replaced, the undersized

grains are still present

Sand in central valve (from backwash)

Filter's bottom strainer is damaged

Air in system

Water level is low or system recently opened

for service

REPAIRS ON THE PUMP SHOULD ONLY BE PERFORMED

BY PROFESSIONALLY TRAINED, QUALIFIED TECHNICIANS.

Solution

Clean the hair and lint strainer.

Tighten hose clamps and connection fittings.

Remove the 4 way valve from tank and clean the seal.

Check the seal, replace if needed.

Tighten clamp. DO NOT overtighten hose clamps

(35 in/lb max torque).

Check the socket and power cord.

Switch on the breaker. If it is immediately tripped again,

there is a defect in pump or controls.

Replace the pump/motor assembly.

Backwash several times until the backwash water is clear.

Purge into drainpipe for 30 seconds.

Replace the filter bottom strainer.

While pump is running, loosen, but do not remove, the pressure

gauge or pressure gauge plug to release air. Then retighten the

gauge or plug.

SAVE THESE INSTRUCTIONS