Maiwe MIEN1203 Benutzerhandbuch - Seite 11

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Schalter Maiwe MIEN1203 herunter. Maiwe MIEN1203 14 Seiten. Industrial ethernet switch

MIEN1203/MIEN2205 Industrial Ethernet Switch

MIEN1203/ MIEN2205/ MIEN2205-S/M provides the terminal equipment

10Base-T/ 100Base-TX Ethernet RJ45 interface, which uses a straight-chain

network cable to connect to the terminal equipment, and a crossover network

cable to connect to the network equipment.

Connect the power supply

MIEN1203/MIEN2205/MIEN2205-S/M devices use power according to the

instructions on the product label. When all other cables are connected, you can

connect to the power supply.

3.3. Fiber optic connection

MIEN1203/MIEN2205-S/M provide 100Base-FX full-duplex single-mode

or multi-mode fiber interface. The type of optical fiber interface can be selected

as SC/ST/FC according to requirements.

Warning:

This switch uses lasers to transmit signals on fiber optic cables. The laser meets

the requirements of Class 1 laser products, and normal operation is harmless to

eyes. However, when the equipment is powered on, do not look directly at the optical

transmission port and the end face of the optical fiber terminator.

The steps to connect the pluggable fiber optic module are as follows:

Remove and keep the rubber cover of SC/ST/FC port. When not in use,

put on a rubber sleeve to protect the optical fiber terminator.

Check whether the optical fiber terminator is clean. Slightly moisten a

clean paper towel or cotton ball, and gently wipe the cable plug. Dirty fiber optic

terminator will reduce the quality of optical transmission and affect port

performance.

Connect one end of the optical cable to the optical fiber interface, and

the other end to the optical fiber interface of another device.

After the connection is completed, please check the corresponding

LINK/ACT indicator of the optical port on the front panel. If the indicator is on,

the connection is valid.

- 7 -