CentralPneumatic 68019 Handbuch für Einrichtung und Betrieb - Seite 15
Blättern Sie online oder laden Sie pdf Handbuch für Einrichtung und Betrieb für Nagelpistole CentralPneumatic 68019 herunter. CentralPneumatic 68019 19 Seiten. 2-in-1 18 gauge nailer-stapler
Auch für CentralPneumatic 68019: Benutzerhandbuch (20 seiten)
Seite drucken
Troubleshooting
Problem
Insufficient
1. Not enough air pressure.
fastener depth.
2. Inadequate lubrication.
3. Blocked air inlet screen (if
4. Mechanism contaminated.
Fasteners drive
1. Incorrect tool depth setting.
too deeply.
2. Too much air pressure.
Tool cycles
1. Jammed fastener.
without firing
fastener.
2. Tool empty.
3. Incorrect fasteners used.
4. Magazine dirty or not
5. Insufficient air flow.
Frequent
Incorrect fastener type.
jamming.
Severe air
1. Cross-threaded housing
leakage.
(Slight air leakage
is normal,
2. Loose housing.
especially on
older tools.)
3. Damaged valve or housing.
4. Dirty, worn or damaged valve.
5. Bent/damaged safety
Follow all safety precautions whenever diagnosing or servicing the tool.
Disconnect air supply before service.
SKU 68019
Possible Causes
equipped).
lubricated properly.
components.
components.
For technical questions, please call 1-800-444-3353.
Likely Solutions
1. Check for loose connections and make sure that air
supply is providing enough air pressure (PSI) to the
tool's air inlet. Do not exceed 120 PSI maximum
air pressure.
2. Lubricate using air tool oil and grease according to
directions.
3. Clean air inlet screen of buildup.
4. Have qualified technician clean and lubricate
mechanism. Install in-line filter in air supply as
stated in Initial Set Up: Air Supply.
1. Adjust depth setting, if available.
2. Reduce air supply pressure (PSI).
1. Clear jammed fastener according to Clearing Jams
instructions.
2. Fill with correct fasteners.
3. Empty, then fill with correct fasteners.
4. Clean and lubricate magazine and pusher.
5. Check for loose connections and make sure that
air supply is providing enough air flow (CFM) and
pressure (PSI) to the tool's air inlet. Do not exceed
120 PSI maximum air pressure.
Confirm fastener diameter, type, length, angle, and
collation type. Correct as needed.
1. Check for incorrect alignment and uneven gaps. If
cross-threaded, disassemble and replace damaged
parts before use.
2. Tighten housing assembly. If housing cannot tighten
properly, internal parts may be misaligned.
3. Replace damaged components.
4. Clean or replace valve assembly.
5. Have tool serviced by qualified service technician.
Page 15