CentralPneumatic 68019 Handbuch für Einrichtung und Betrieb - Seite 7
Blättern Sie online oder laden Sie pdf Handbuch für Einrichtung und Betrieb für Nagelpistole CentralPneumatic 68019 herunter. CentralPneumatic 68019 19 Seiten. 2-in-1 18 gauge nailer-stapler
Auch für CentralPneumatic 68019: Benutzerhandbuch (20 seiten)
Seite drucken
FUNCTIONAL DESCRIPTION
Functional Description
Specifications
Operating Air
Pressure
Max. Air Pressure
Air Consumption
Air Inlet
Fastener Types
Magazine Capacity
Safety
Components and Controls
Air Deflector
Safety (26)
Safety Nosepiece - Also called the workpiece
contact, the Safety Nosepiece helps
prevent the tool from firing unless it is
pressed against an object.
Initial Tool Setup/Assembly
INITIAL TOOL SET UP/
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set up
or use of this product.
SKU 68019
70-120 PSI
120 PSI
.5 CFM @ 90 PSI
1/4" -18 NPT
18 Gauge 5/8" - 2" Brad Nails
18 Gauge 5/8" - 1-5/8" Narrow
Crown Staples
100 Fasteners
Full Sequential Trip Safety
(26)
Air Inlet
Plug (69)
Trigger
(36)
For technical questions, please call 1-800-444-3353.
Note: For additional information regarding
parts listed in following pages, refer to
Assembly Diagram near end of manual.
When unpacking, make sure the item
is intact and undamaged. If any parts are
missing or broken, please call Harbor Freight
Tools at 1-800-444-3353 as soon as possible.
• This air tool may be shipped with a
protective plug covering the air inlet.
Remove this plug before set up.
Use only clean, dry, regulated,
compressed air to power this
tool. Do not use oxygen, carbon
dioxide, combustible gases, or
any other bottled gas as a power
source for this tool.
1.
Connect a regulator valve, an in-line shut
Latch
off valve and 1/4" NPT air hose (all sold
(64)
separately) to the Quick Coupler. Use
thread tape on all threaded connections.
The air hose must be long enough to
reach the work area with enough extra
length to allow free movement while
working. An in-line shutoff ball valve
is an important safety device because
it controls air supply even if the air
hose is ruptured. The shutoff valve
should be a ball valve because it can
be closed quickly. See pages 8 and 9
for Air Tool Setup procedures.
Note: If an automatic oiler system is not
used, add a few drops of Pneumatic
Tool Oil into the airline connection before
operation. Add a few more drops after
each hour of continual use.
Unpacking
Air Supply
TO PREVENT
EXPLOSION:
Page 7