Majestic MERID42IN Einbauanleitung

Blättern Sie online oder laden Sie pdf Einbauanleitung für Innenkamin Majestic MERID42IN herunter. Majestic MERID42IN 3 Seiten. Glass refractory kit

Seite drucken

Models: MERID36IN, MERID36IL, MERID42IN, MERID42IL,

Leave this manual with party responsible for use

and operation.

DANGER

DO NOT TOUCH GLASS

NEVER ALLOW CHILDREN

A barrier designed to reduce the risk of

burns from the hot viewing glass is provided

with this appliance and shall be installed for

the protection of children and other at-risk

individuals.

CAUTION! Do not install damaged components.

CAUTION! Risk of Cuts or Abrasions. Wear protective

gloves and safety glasses during installation.

NOTICE: Handle glass refractory panels with care.

Refractory may chip or crack if dropped or impacted.

REQUIRED TOOLS

Screw gun equipped with 1/4 in (6 mm). socket or

1/4 in. (6 mm). wrench or socket

Small, flat screwdriver

KIT COMPONENTS

(2) Side Glass Refractory Panels

(1) Rear Glass Refractory Panel

(1) Top Glass Refractory Panel

(2) Side Refractory Bracket

(1) Rear Refractory Bracket

(1) Rear Exhaust Baffle

(3) Screws

Installation Instructions

1. Remove decorative front and logs.

2. Remove existing refractory or false back and discard,

if installed.

3. Remove fiber refractory brackets (if so equipped) and

insert screws in the holes that remain. See Figure 1.

GLASS REFRACTORY KIT

GL36MER, GL42MER

MERIDPLA36IN, MERIDPLA36IL, MERIDPLA42IN, MERIDPLA42IL

Installation Instructions

HOT GLASS WILL

CAUSE BURNS.

UNTIL COOLED.

TO TOUCH GLASS.

Majestic • GL36MER, GL42MER Installation Instructions • 2502-931 Rev. B • 3/18

WARNING!

Risk of Asphyxiation!

holes open! Screws from fiber refractory bracket removal

MUST be reinstalled in same holes as removed to main-

tain firebox seal.

Figure 1. Remove Fiber Refractory Brackets. Install Screw.

4. Locate the six tabs on the basepan and bend upward.

They are circled in Figure 2. There are two tabs on

each side and two in the back.

BEND 6 BASEPAN TABS

Figure 2. Basepan Tab Locations

5. Using a small, flat screwdriver, bend the ends of the

refractory brackets to a 90 degree angle as shown

in Figure 3. Break side refractory brackets apart by

bending back and forth.

DO NOT leave

INSTALL SCREW