Majestic MERID42IN Istruzioni per l'installazione
Sfoglia online o scarica il pdf Istruzioni per l'installazione per Camino da interno Majestic MERID42IN. Majestic MERID42IN 3. Glass refractory kit
Models: MERID36IN, MERID36IL, MERID42IN, MERID42IL,
Leave this manual with party responsible for use
and operation.
DANGER
DO NOT TOUCH GLASS
NEVER ALLOW CHILDREN
A barrier designed to reduce the risk of
burns from the hot viewing glass is provided
with this appliance and shall be installed for
the protection of children and other at-risk
individuals.
CAUTION! Do not install damaged components.
CAUTION! Risk of Cuts or Abrasions. Wear protective
gloves and safety glasses during installation.
NOTICE: Handle glass refractory panels with care.
Refractory may chip or crack if dropped or impacted.
REQUIRED TOOLS
Screw gun equipped with 1/4 in (6 mm). socket or
1/4 in. (6 mm). wrench or socket
Small, flat screwdriver
KIT COMPONENTS
(2) Side Glass Refractory Panels
(1) Rear Glass Refractory Panel
(1) Top Glass Refractory Panel
(2) Side Refractory Bracket
(1) Rear Refractory Bracket
(1) Rear Exhaust Baffle
(3) Screws
Installation Instructions
1. Remove decorative front and logs.
2. Remove existing refractory or false back and discard,
if installed.
3. Remove fiber refractory brackets (if so equipped) and
insert screws in the holes that remain. See Figure 1.
GLASS REFRACTORY KIT
GL36MER, GL42MER
MERIDPLA36IN, MERIDPLA36IL, MERIDPLA42IN, MERIDPLA42IL
Installation Instructions
HOT GLASS WILL
CAUSE BURNS.
UNTIL COOLED.
TO TOUCH GLASS.
Majestic • GL36MER, GL42MER Installation Instructions • 2502-931 Rev. B • 3/18
WARNING!
Risk of Asphyxiation!
holes open! Screws from fiber refractory bracket removal
MUST be reinstalled in same holes as removed to main-
tain firebox seal.
Figure 1. Remove Fiber Refractory Brackets. Install Screw.
4. Locate the six tabs on the basepan and bend upward.
They are circled in Figure 2. There are two tabs on
each side and two in the back.
BEND 6 BASEPAN TABS
Figure 2. Basepan Tab Locations
5. Using a small, flat screwdriver, bend the ends of the
refractory brackets to a 90 degree angle as shown
in Figure 3. Break side refractory brackets apart by
bending back and forth.
DO NOT leave
INSTALL SCREW
1