Gamma 5002 Benutzerhandbuch - Seite 7

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Besaitungsmaschinen Gamma 5002 herunter. Gamma 5002 18 Seiten.

Gamma 5002 Benutzerhandbuch
cleaning, the post and tube should be treated with a light coating of machine oil to protect the
surfaces against corrosion and to ensure smooth operation.
ASSEMBLY INSTRUCTIONS
Place the load bushing into the top of the
clamp base mating it to the lower guide
bushing. After checking that the thrust bear-
ing is positioned correctly in the base of the
winged lock knob, screw the knob into the
base bushing until fully seated.
The post of the string clamp head and tube
of the string clamp base are treated with
grease to provide protection against corro-
sion during shipping. Remove any exces-
sive grease with a clean cloth prior to use.
The post and tube may also be cleaned with
isopropyl alcohol. After this type of thorough
Locking the Turntable
The turntable may be locked in any position.
The turntable winged lock knob is packed
separately in the accessory polybag. Install
the lock knob into the threaded hole located
on the side of the tensioner bar post.
Rotate the knob clockwise to lock the turn-
table, and counter-clockwise to release the
turntable.
Installing the Tensioner
Remove the button head screw and washer
located at the end of the tensioner bar with
the 3 mm hex wrench provided. Slide the
tensioner onto the bar, being careful to align
the bar with all of the bearings and the drive
gear with the gear track. Replace the button
head screw and washer in the end of the
tensioner bar.
6