Gamma 5002 Owner's Manual - Page 7

Browse online or download pdf Owner's Manual for Stringing Machines Gamma 5002. Gamma 5002 18 pages.

Print Page

cleaning, the post and tube should be treated with a light coating of machine oil to protect the

surfaces against corrosion and to ensure smooth operation.

ASSEMBLY INSTRUCTIONS

Place the load bushing into the top of the

clamp base mating it to the lower guide

bushing. After checking that the thrust bear-

ing is positioned correctly in the base of the

winged lock knob, screw the knob into the

base bushing until fully seated.

The post of the string clamp head and tube

of the string clamp base are treated with

grease to provide protection against corro-

sion during shipping. Remove any exces-

sive grease with a clean cloth prior to use.

The post and tube may also be cleaned with

isopropyl alcohol. After this type of thorough

Locking the Turntable

The turntable may be locked in any position.

The turntable winged lock knob is packed

separately in the accessory polybag. Install

the lock knob into the threaded hole located

on the side of the tensioner bar post.

Rotate the knob clockwise to lock the turn-

table, and counter-clockwise to release the

turntable.

Installing the Tensioner

Remove the button head screw and washer

located at the end of the tensioner bar with

the 3 mm hex wrench provided. Slide the

tensioner onto the bar, being careful to align

the bar with all of the bearings and the drive

gear with the gear track. Replace the button

head screw and washer in the end of the

tensioner bar.