Gamma PROGRESSION 600ES-LED Benutzerhandbuch - Seite 8
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Besaitungsmaschinen Gamma PROGRESSION 600ES-LED herunter. Gamma PROGRESSION 600ES-LED 17 Seiten.
Seite drucken
friction between the clamps and the string to allow for reduced clamping pressure while securing
and holding the string under tension.
tremely high tensions, additional tightness may be required. Note: If the string slips in the
string clamp while tensioning, adjust the gap between the clamp jaws as per the
instructions on page 11.
STRINGING THE FRAME
Fixed Clamp Operation - Step 1
The fixed clamps for the GAMMA 600ES are
of a dual action design. The string clamp and
the clamp base operate independently of one
another.
To clamp a string, lift the clamp head and
place the string between the jaws. Depress
the clamp head lever to secure the string.
The clamping pressure applied to the string
should be adjusted to provide sufficient pres-
sure to secure the string when subjected to
the desired pulling tension. The diamond
coated gripper plates provide for increased
Fixed Clamp Operation - Step 2
Rotate the winged lock knob clockwise to
secure the clamp base to the turntable.
Reverse the clamping procedure to unlock
the string clamp.
The winged lock knob should be tightened
enough to prevent clamp base slippage on
the turntable, when the desired tension is
placed on the string. To go from the loose
position to the clamped position and back,
generally requires about 1/2 to 3/4 quarters
of a turn. Although when stringing at ex-
Clamping the First Main String
To begin stringing the main strings, thread
the two ends of the string through the two
center holes at the appropriate end of the
frame and continue through the opposite
center holes. Thread one end of the string
through the adjacent grommet hole and pull
excess by hand.
Secure one of the strings using a string
clamp.
7