Gamma PROGRESSION 600ES-LED 소유자 매뉴얼 - 페이지 8

{카테고리_이름} Gamma PROGRESSION 600ES-LED에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma PROGRESSION 600ES-LED 17 페이지.

friction between the clamps and the string to allow for reduced clamping pressure while securing

and holding the string under tension.

tremely high tensions, additional tightness may be required. Note: If the string slips in the

string clamp while tensioning, adjust the gap between the clamp jaws as per the

instructions on page 11.

STRINGING THE FRAME

Fixed Clamp Operation - Step 1

The fixed clamps for the GAMMA 600ES are

of a dual action design. The string clamp and

the clamp base operate independently of one

another.

To clamp a string, lift the clamp head and

place the string between the jaws. Depress

the clamp head lever to secure the string.

The clamping pressure applied to the string

should be adjusted to provide sufficient pres-

sure to secure the string when subjected to

the desired pulling tension. The diamond

coated gripper plates provide for increased

Fixed Clamp Operation - Step 2

Rotate the winged lock knob clockwise to

secure the clamp base to the turntable.

Reverse the clamping procedure to unlock

the string clamp.

The winged lock knob should be tightened

enough to prevent clamp base slippage on

the turntable, when the desired tension is

placed on the string. To go from the loose

position to the clamped position and back,

generally requires about 1/2 to 3/4 quarters

of a turn. Although when stringing at ex-

Clamping the First Main String

To begin stringing the main strings, thread

the two ends of the string through the two

center holes at the appropriate end of the

frame and continue through the opposite

center holes. Thread one end of the string

through the adjacent grommet hole and pull

excess by hand.

Secure one of the strings using a string

clamp.