Gamma X-ST Benutzerhandbuch - Seite 15

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Besaitungsmaschinen Gamma X-ST herunter. Gamma X-ST 19 Seiten.
Auch für Gamma X-ST: Benutzerhandbuch (19 seiten), Benutzerhandbuch (19 seiten)

Seite drucken

MAINTENANCE & ADJUSTMENTS

wise to open the gap between the jaws. The clamp jaws should be cleaned periodically to

be free from dirt, oil, and any string coating for them to grip properly. Knife sharpening stones

are excellent for removing build-up on the diamond coated surfaces and are available.

Note: The string clamps supplied with your stringing machine can accomodate tight string

patterns such as badminton. Depending on the string pattern, the clamp may spread the strings

slightly which will not compromise the quality of the string job. String clamps specifically

designed for badminton racquets are also available.

Adjusting the String Clamp Jaw Spacing

The string clamps will need minor adjustments according

to what string type, construction, and gauge you are

using.

To adjust the gap (clamping pressure) between the clamp

jaws, insert the string through the racquet as if you were

beginning the main strings. Clamp the strings and pull

tension. If the string slips through the jaws of the clamp,

tighten the clamp by compressing the clamp jaws together

by hand while turning the Adjustment Knob, in the clock-

Adjustment

wise direction. If the clamp leaves impressions or dam-

Knob

ages the string, it may be excessively tight and should be

adjusted by turning the Adjustment Knob counter clock-

Clamp Base Locking Nut Adjustment

In the event the Locking Lever rotation is

insufficient to ensure smooth operation of

the clamp base, very minor adjustments to

the Clamp Base Locking Nut can be made

with the supplied 17mm socket. Tighten or

loosen the locking nut in very small incre-

ments to provide more clamping pressure or

running clearance as needed.

Quick Action Clamp Base Removal

Quick Action clamp bases can be removed

from the turntable for maintenance or clean-

ing by removing clamp stop located at the end

of the slot in the turntable. To remove the

clamp stop, remove the two screws holding

the clamp stop in place from the underside of

the turntable. Lift the clamp stop out of the

slot, slide the clamp base to the end of the slot

and lift it out. Replace the clamp base and

clamp stop in reverse order.