Gamma X-ST Manuale d'uso - Pagina 15

Sfoglia online o scarica il pdf Manuale d'uso per Macchine incordatrici Gamma X-ST. Gamma X-ST 19.
Anche per Gamma X-ST: Manuale d'uso (19 pagine), Manuale d'uso (19 pagine)

Gamma X-ST Manuale d'uso
MAINTENANCE & ADJUSTMENTS
wise to open the gap between the jaws. The clamp jaws should be cleaned periodically to
be free from dirt, oil, and any string coating for them to grip properly. Knife sharpening stones
are excellent for removing build-up on the diamond coated surfaces and are available.
Note: The string clamps supplied with your stringing machine can accomodate tight string
patterns such as badminton. Depending on the string pattern, the clamp may spread the strings
slightly which will not compromise the quality of the string job. String clamps specifically
designed for badminton racquets are also available.
Adjusting the String Clamp Jaw Spacing
The string clamps will need minor adjustments according
to what string type, construction, and gauge you are
using.
To adjust the gap (clamping pressure) between the clamp
jaws, insert the string through the racquet as if you were
beginning the main strings. Clamp the strings and pull
tension. If the string slips through the jaws of the clamp,
tighten the clamp by compressing the clamp jaws together
by hand while turning the Adjustment Knob, in the clock-
Adjustment
wise direction. If the clamp leaves impressions or dam-
Knob
ages the string, it may be excessively tight and should be
adjusted by turning the Adjustment Knob counter clock-
Clamp Base Locking Nut Adjustment
In the event the Locking Lever rotation is
insufficient to ensure smooth operation of
the clamp base, very minor adjustments to
the Clamp Base Locking Nut can be made
with the supplied 17mm socket. Tighten or
loosen the locking nut in very small incre-
ments to provide more clamping pressure or
running clearance as needed.
Quick Action Clamp Base Removal
Quick Action clamp bases can be removed
from the turntable for maintenance or clean-
ing by removing clamp stop located at the end
of the slot in the turntable. To remove the
clamp stop, remove the two screws holding
the clamp stop in place from the underside of
the turntable. Lift the clamp stop out of the
slot, slide the clamp base to the end of the slot
and lift it out. Replace the clamp base and
clamp stop in reverse order.
14