CenturionPro Original Benutzerhandbuch - Seite 11
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Trimmer CenturionPro Original herunter. CenturionPro Original 20 Seiten.
Seite drucken
CLEANING & MAINTENANCE
BLADE REMOVAL
For optimal performance and life, the BLADE and the MAGNET BAR must be removed and cleaned every
STEP 1:
UNLOCK BLADE
- Remove 3/32" bolt
- Loosen the surrounding set screws ONLY
IMPORTANT NOTE:
YOUR BED BAR BLADE HAS BEEN FACTORY SET TO CUT PERFECTLY. PLEASE DO NOT ALTER THE SETTINGS OF YOUR MACHINE. YOU
MIGHT NOTICE SLIGHT CONTACT BETWEEN YOUR ROTATING CUTTING REEL AND THE FLAT BED BAR BLADE - THIS IS NORMAL.
CLEANING THE ORIGINAL & SILVER BULLET
For optimal performance and life, the components must be cleaned after every day of operation.
STEP 1:
CLEAN
BRUSH
Clean the length
of the brush of all
debris using hot
pressurized water.
For more information or to watch our DIY video tutorials visit cprosolutions.com
Aduster Block
Set Screw
STEP 2:
UNLOCK BLADE
- Push adjuster block out with attached blade
- Push forward until blade slides onto reel, and lift.
STEP 2:
CLEAN
ELECTROPLISH
TUMBLER
Clean the length of
the tumbler of all
debris using hot
pressurized water.
3-4 hours
of operation. It is important to remove the blade with the adjustors in.
Blade Adjusters
act as handles
to safely handle
and position
your blade.
STEP 3:
BLADE REMOVAL
- Carefully slide blade off magnet
- Carefully Remove bed bar blade
STEP 3:
CLEAN CUTTING
REEL & SHROUD
Clean the length of the
cutting reel and shroud
of all debris using hot
pressurized water.
IMPORTANT NOTE:
- Clean with pressure-washer at up to 1500 psi.
- Hot water, fan spray setting
- Run TableTop for 15 mins after washing to allow components to dry
- DO NOT pressure-wash Quantanium Coated tumblers (see page. 15)
OWNERS MANUAL
THE ORIGINAL & SILVER BULLET
STEP 4:
BLADE & MAGNET CLEANING
- Clean blade and magnet bar with a utility knife.
INSTALLATION IS REVERSE ORDER OF REMOVAL
AVOID
AVOID
WATER
WATER IN
ON THE
BEARINGS
MOTOR
11