Decofire Halo Series Montage-, Sicherheits- und Betriebsanleitung - Seite 8
Blättern Sie online oder laden Sie pdf Montage-, Sicherheits- und Betriebsanleitung für Heizgerät Decofire Halo Series herunter. Decofire Halo Series 17 Seiten. Rapid reduction area heater
Seite drucken
Step 1.
Before assembly commences, ballast must be added to
the cylinder housing / base.
Remove the plastic plug at the center of the base, then
pour in approx 7.5KGS of sand into the base.
(About 3/4 of the container volume).
Step 3.
Attach the cylinder housing support (G) to the cylinder
enclosure (D) using one M8 x 16 screw (CC) at the
base (Pointing Downwards into the base) and two
M5x12 screws (AA), to attach the cylinder support to
the back of the cylinder enclosure.
Do not fully tighten to allow room for adjustment later
in the assembly process.
Important: The top M5x12 screw (AA) must be
temporarily removed and replaced in step 4, when fitting
the burner assembly.
D
CC
Page 8
Plug
AA
G
AA
Step 2.
Once the sand is placed, then slowly fill the base with
water until it reaches the top of the container rim.
Reinsert the plug and clean off any spills.
Step 4.
Align the holes at the bottom of the burner assembly
(C) with the top of the cylinder enclosure (D).
Position both assemblies so that the control panel on
the burner assembly (C) is aligned with the door on the
cylinder enclosure (D).
Through the aligned screw holes attach the burner (C)
to the top of the cylinder housing (D) using four M6 x
12 screws (BB) and four M6 lock nuts (DD).
Important: The top M5x12 screw (AA) must be
temporarily removed and replaced when fitting the
burner assembly.
Tighten the screws firmly to complete this step.
C
AA
DD x 4
Plug
BB x 4
D