Decofire Halo Series 조립, 안전 및 작동 지침 - 페이지 8

{카테고리_이름} Decofire Halo Series에 대한 조립, 안전 및 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Decofire Halo Series 17 페이지. Rapid reduction area heater

Step 1.

Before assembly commences, ballast must be added to

the cylinder housing / base.

Remove the plastic plug at the center of the base, then

pour in approx 7.5KGS of sand into the base.

(About 3/4 of the container volume).

Step 3.

Attach the cylinder housing support (G) to the cylinder

enclosure (D) using one M8 x 16 screw (CC) at the

base (Pointing Downwards into the base) and two

M5x12 screws (AA), to attach the cylinder support to

the back of the cylinder enclosure.

Do not fully tighten to allow room for adjustment later

in the assembly process.

Important: The top M5x12 screw (AA) must be

temporarily removed and replaced in step 4, when fitting

the burner assembly.

Page 8

Plug

Step 2.

Once the sand is placed, then slowly fill the base with

water until it reaches the top of the container rim.

Reinsert the plug and clean off any spills.

Step 4.

Align the holes at the bottom of the burner assembly

Position both assemblies so that the control panel on

the burner assembly (C) is aligned with the door on the

cylinder enclosure (D).

Through the aligned screw holes attach the burner (C)

to the top of the cylinder housing (D) using four M6 x

12 screws (BB) and four M6 lock nuts (DD).

Important: The top M5x12 screw (AA) must be

temporarily removed and replaced when fitting the

burner assembly.

Tighten the screws firmly to complete this step.

DD x 4

Plug

BB x 4