Century Helicopter Products Bell 47G II ARF Helicopter Handbuch - Seite 12

Blättern Sie online oder laden Sie pdf Handbuch für Spielzeug Century Helicopter Products Bell 47G II ARF Helicopter herunter. Century Helicopter Products Bell 47G II ARF Helicopter 15 Seiten.

Seite drucken

Century Helicopter Products Bell 47G II ARF Helicopter Handbuch

STEP 18 Tail Wire Skid

Loosen the end M3x10 Socket Cap Screw and insert the

tail wire into the hole in the end of the gear box. Tighten

the screw to secure. Insert the front end into the bottom of

the tail tube mount and secure with one M3x4 Set Screw

using threadlock inserted horizontally into the mount.

STEP 19 Horizontal Fin

Bond the end caps to the horizontal fin using "Goop" or CA

adhesive. Assemble two horizontal fin mounts around the

upper main truss rails using two M2x6 Phillips Head Screws

and M2 Hex Nuts using threadlock. Slide the horizontal fin

through the second open section from the rear of the truss and

adjust the mounts until they align perfectly with the molded

recesses in the fin. Attach the fin in place using four M3x6 Self

Tapping Screws. To avoid the screws piecing through the

bottom of the fin, cut the point off the screw, about 1/3rd of the

length and test fit. Trim more if necessary.

Horizontal Fin

& End Caps

[CN1074-5]

M2x6 Phillips Head Screws x 2

M2 Hex Nut x 2

M3x6 Self Tapping Screws x 4

STEP 21 Rudder Pushrod

Assemble two drive shaft guides and attach them upside down from

1st & 3rd horizontal braces. Slide the long rudder pushrod from the

back, then through one guide positioned at the 3rd brace, slide a

short clear pushrod guide tube through the guide and bond in place

with CA adhesive. Attach the pushrod coupler and the short 105mm

pushrod and insert through the guide on the last horizontal brace

before the rudder servo. Ensure the pushrod is moving smoothly. Make sure the "Century" ball link is

attached to the short (2.3mm) pushrod and the black ball link to the long (2.0mm) pushrod.

Horizontal Fin

Mounts x 2

[CN1074-5]

M2x10 Phillips Head

Screws x 3

M2 Hex Nuts x 3

Bell47G II Detail Manual

Tail Wire Skid

[CN1074-12]

Vertical Fin

one half of the vertical fin

[CN1074-5]

mount, then through the fin

and the opposite fin mount

capturing the bottom rail of

the tail truss and securing

with one M2 Hex nut using

Vertical Fin

threadlock. Repeat for the

Mounts x 3

[CN1074-5]

Rudder Pushrod Set

M3x4 Set

Screw

STEP 20 Vertical Fin

Attach the vertical fin by

inserting one M2x10

Phillips Head Screw into

remaining holes.

[CN1074-13]