Century Helicopter Products Hummingbird Elite Series CP Gebrauchsanweisung - Seite 8

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Spielzeug Century Helicopter Products Hummingbird Elite Series CP herunter. Century Helicopter Products Hummingbird Elite Series CP 12 Seiten. Elite series helicopter

Seite drucken

Century Helicopter Products Hummingbird Elite Series CP Gebrauchsanweisung

Section 5

INSTALLING ELECTRONICS TO YOUR HUMMINGBIRD ELITE

The electronics used to operate the Hummingbird Elite helicopter install with servo tape.

This will securely mount the electronic components to the frame of the helicopter for proper

operation. Be sure that the diagram on page 4 reflects the wiring connections that you

make to the mounted model. (note: the below photos are an example layout)

1. Mount the mixer board.

4. Plug in channel 1 for aileron servo.

7. Plug mixer rudder lead into gyro

(signal wires must face each other).

ROUTING THE ANTENNA

To provide the best possible reception for the model, the Hummingbird Elite comes with a plastic tube for

routing the antenna. Put a small hole in one end and pull the antenna all the way through leaving about 2

to 3 inches of slack. Wrap the antenna around the tube. After the antenna is almost completely wrapped

around the plastic tube place a hole at the other end of the tube to secure the end of the antenna. The

Hummingbird Elite series helicopters have brackets in the landing gear for mounting this plastic tube.

Place a hole

here using a

thumb tack.

MOUNTING THE BATTERY

The Hummingbird uses a NiMH battery. Both 8.4V and 9.6V Bird Seed batteries will work and fit in

the provided battery brackets using a rubber band.

1. The battery slides back and forth on it's supports so you can adjust the center of gravity on the

helicopter.

2. To test your results hold the helicopter by the flybar as pictured. Move the batery to have the

helicopter sit level or very slightly nose heavy.

Battery

brackets

Rubber

band

R R R R R adio inst

adio inst

adio install

adio inst

bat t t t t tery mounting

tery mounting

2. Mount the gyro (mount the gyro with

the word "Century" oriented as pictured).

5. Plug in channel 2 for elevator servo.

8. Plug gyro into channel 4 for rudder.

alla a a a a tion and

all

tion and

all

tion and

3. Mount the receiver.

6. Plug in channel 3 for throttle (mixer board).

9. For CP Hummingbird plug 3rd servo

(collective pitch) into channel 6.

Place a hole

here using a

thumb tack.

BREAKING IN THE 370 MOTOR

Items required:

1x cup of water

2x D-cell batteries

1x series 3-volt D cell battery

holder (example: Radio Shack

part number

270-386A)

1x (Optional) female connector

First remove the main motor by

locating and removing the two mounting screws under

the main chassis. Immerse the motor in a cup of water.

Connect the motor to the 3 volt battery holder Red wire

to red wire black wire to black wire. (Tip – a female

connector can be attached to the battery box for quick

connection to the motor). Install batteries and Run

motor for four minutes to a maximum of five minutes.

Remove motor from water immersion and dry. Place

one drop of light oil (CN2024T Tri-Flow oil) on each

brass bushing for lubrication. Reinstall motor checking

carefully for smooth gear mesh.

(This procedure is only required to be performed once

and only on a new motor).

Warning: Breaking in the motor is not "required"

Manufacturer is not responsible for problems related

with motor break-in.

Servo tape

Helpful Hint