Century Helicopter Products Predator 70 Gebrauchsanweisung - Seite 10
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Spielzeug Century Helicopter Products Predator 70 herunter. Century Helicopter Products Predator 70 20 Seiten.
Seite drucken
#HW6001 Main Shaft M3 Pin
Insert the main gear assembly from the side and slide the
main shaft through the upper main shaft bearing block. Align
the M4 threaded hole with 3mm hole on the main shaft and
insert the pin.
#HW6054 Bottom Collar &
M3x6 Flat head screws x 2
Inspect the bottom collar, make sure the step in the collar is
towards the ball bearing. Press firmly on the main shaft until
the top threaded hole aligns with the holes in the bottom
collar. Apply locktight to the M3 Flat head screws.
To set the upper mast stopper, press down firmly on the main
shaft and tighten the M2.6 Socket screw using locktight.
Install the starting shaft, pull up on the shaft and apply
locktight to the top of the shaft and position one of the set
screws on the flat spot.
10
Main gear
assembly, slipper
or constant drive
type.
Slipper
Main Gear
#HW6053 Main Shaft
#HW6054
Mast Stopper
& M2.6x8
Socket screw
#HW6002
Hex Coupler
& M4x4 Set
Screw x 2
43
#HW6001 M4x4 Set Screw x 2
After the main shaft pin is started, press it in and start
threading the M4 set screws. Continue adjusting until the pin
is centered in the autohub assembly. Remove one at a time
and apply locktight. These do not need to torqued down.
45
#HW6054 Bottom Collar &
M3x6 Flat head screws x 2
Install the main shaft thrust bearing (SE & Max only) and
0.25mm shim against the lower bearing followed by the bottom
collar. Make sure the step in the collar is away from the thrust
bearing. Apply locktight to the two M3 Flat head screws.
#HW6005
47
Starting
Shaft
#HW6011
Clutch Shoe
#HW6009
Cooling Fan
Check once more that everything is ready on the engine.
Make sure that the carburetor has been seated properly and
the securing screw is tight.
44
46
#CNBB1018T
& 0.25mm Shim
Constant
Drive
Main Gear
48
Completed
engine
assembly.