IKEA IHI8304WS0 Installationsanleitung und Gebrauchs- und Pflegeanleitung - Seite 11

Blättern Sie online oder laden Sie pdf Installationsanleitung und Gebrauchs- und Pflegeanleitung für Lüftungshaube IKEA IHI8304WS0 herunter. IKEA IHI8304WS0 28 Seiten. 30" (76.2 cm) island canopy range hood

Seite drucken
RANGE HOOD CARE
IMPORTANT:
Clean the hood and grease filters frequently
according to the following instructions. Replace grease filters
before operating hood.
Check that lights are cool before cleaning the hood.
Exterior Surfaces
Clean the range hood with a mild detergent and soft cloth. To
avoid damage to the exterior surface, do not use abrasive
cleanser or steel-wool pads.
Metal Grease Filters
The filters should be washed frequently. Place metal filters in
dishwasher or hot detergent solution to clean.
Drain water through edge holes and let each filter dry thoroughly
before replacing it.
To Remove
Metal Filter:
1. Turn off blower and lights.
2. Push handle toward the rear and pull downward.
3. Pull filter toward the front.
To Replace
Metal Grease Filter:
1. Insert back edge of filter into rear channel of the filter
opening.
2. Push handle toward the rear and push filter up.
3. Pull filter toward the front and insert into front channel.
Charcoal Filters - For Non-Vented (recirculating)
Installations
The charcoal filters capture unpleasant cooking odors. They can
be cleaned and reactivated. With normal use the filter should be
cleaned every second month (when using the hood 2.5 hours per
day, on average).
Clean the filter in the dishwasher using normal detergent and
choosing the highest temperature setting. Wash the filter
separately. To reactivate the filter, the filter should be dried in
an oven for 10 minutes with a maximum temperature
of
210°F (100°C).
After approximately
3 years of use, the charcoal filter should be
replaced. See "Assistance
or Service" section to order
replacement charcoal filters.
To Replace Charcoal
Filter:
1. Turn off blower and lights. Check that range hood is off and
halogen lamp is cool.
2. Remove the metal grease filters by pushing handle toward
the rear and pull downward.
3. Pull filter toward front.
4. Set the filter face down on a cover such as a towel.
5. Remove metal wires and clean or discard charcoal filter.
6. Install cleaned or replacement charcoal filter on rear of metal
filter with metal wires provided in filter packaging.
To Replace
Metal Grease Filter:
1. Insert back edge of filter into rear track of the filter opening.
2. Push handle toward the rear and push filter up.
3. Pull filter toward the front and insert into front track.
Replacing
a Halogen
Lamp
Turn off the range hood and allow the halogen lamps to cool. To
avoid damage or decreasing the life of the new bulb, do not
touch bulb with bare fingers. Replace bulb, using tissue or
wearing cotton gloves to handle bulb.
If new lights do not operate, make sure the lamps are inserted
correctly before calling service.
1. Disconnect
power.
2. Use a flat-blade screwdriver and gently pry the light cover
loose.
3. Remove the lamp and replace with a 12-volt, 20-watt
maximum, halogen lamp made for a G-4 base.
4. Replace the light cover.
5. Reconnect power.
11