KitchenAid KUDD01DPPA0 Installationsanleitung Handbuch - Seite 13
Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Geschirrspüler KitchenAid KUDD01DPPA0 herunter. KitchenAid KUDD01DPPA0 16 Seiten. Drawer dishwasher
Seite drucken
Option 2: Install custom front panels
Custom
front
panem dimensions
9 ==
I"_-- (22.9 cm)
medallion
cutout area
Top panel
(frontview)
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
23-7/16" (59.5 cm)
2-5/16"
(5_9cm)
2-1/8"
medallion
cutout area
Bottom panel
(frontview)
23-7/18" (59.5 cm)
1_9/32"
1-7/32"
(32.8 mm)
2-13/32"
(60.8 ram)
NOTE: Do not cut
beyond outline of
medallion cutout_
Rout a 1/4" (6,4 ram)
radius around back side
--1-13/84"
of medallion cutout,
(30_6 ram)
Medallion cutout
(frontof panel)
1.
Prepare
the custom
front
panels
to specifications
shown.
2.
Mount
the handle
to the custom
panel.The
screws
must
not extend
beyond
the back surface
of the panel.
(Handle
is customer
supplied,
location
is customer
preference.)
3.
Lay the custom
front
panel
face down
on a protective
covering.
4.
Measure
and mark
the vertical
centedine
and horizontal
position
line on the back of the front
panels.
_(_
_ark
Top Panel -
_
horizontalline
1-7/16" (36.5 ram)
_
mark
Bottom panel -
1-3/16" (30.2 ram)
centerline
5.
Feed the wires
of the medallion
connector
through
the
front
of the custom
front
panel
and push
the medallion
into the prepared
medallion
hole.
6.
Remove
the pins
on both
sides
of the dishwasher
drawer
by pulling
the pins
straight
out with
a pair of needle-
nose
pliers.
pin
.........
/
7. Gently
pull the bottom
of the metal plate away from the
dishwasher,
and then pull down.
Upper and lower panel minimum thickness is 5/8" (16 mm). Panel
thickness above 11/!6" (18 mm) can be accommodated
but
product depth will increase accordingly.
Custom front panel materia! must be suitable for damp
conditions or adequately sealed to withstand moisture.
Using a
moisture-resistant
material can provide additional protection.
Taping edges alone may not provide adequate sealing. For
painted panel, paint all rear edges to improve sealing.
8. Lay the custom front panel face dovvn,
9. Feed the medallion
wires through
the wire opening
in
the metal plate,
wire opening
..................
front panel
13