Avantco 194CDIM50 Benutzerhandbuch - Seite 2

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Eiswürfelbereiter Avantco 194CDIM50 herunter. Avantco 194CDIM50 2 Seiten. Countertop dry ice machine

Seite drucken

User Manual

Warning and Safety

WARNING: This product works with liquid CO2 only, do not use other compressed gas cylinders with high pressure

or non-liquid CO2. A liquid CO2 cylinder with siphon tube is recommended for effective delivery of liquid CO2. A

non-liquid CO2 cylinder may be used if the tank is inverted (turned upside down). Install this product in a well-venti-

lated area to assist in venting excess CO2.

WARNING: Dry Ice can cause burns or other injuries if not properly handled. Always use PPE such as gloves while

handling dry ice.

Set-up & Operation:

NOTE: Do not use the dry ice machine when any part of it is wet

Place unit on level surface, that is a comfortable work height for operator

Place steel wire for connection hose around the CO2 tank

Add rubber seal rings to inside of connection hose nut, then connect to CO2 tank

Tighten using hands, then use a wrench to tighten it.

NOTE: do not overtighten

Plug unit into appropriate 120V 5-15 outlet.

Screw ice tube into the unit

Slowly open CO2 tank, ensuring no leaks in the system, then fully open CO2 tank

Press and release the red power button to turn the unit on

Press and release the blue operation button to start the dry ice production

NOTE: Do not press the blue button without the ice tube fully engaged

10.

After approximately 2-3 minutes, the dry ice will be formed in the ice tube

11.

Using gloves, unscrew the ice tube and remove the dry ice from the tube using gravity

12.

At business close, turn the unit off and close the CO2 tank

Replacing CO2 Cylinder:

When the machine does not make a complete dry ice block, this is an indication that it is time to change the cylinder.

Close the shut-off valve of the CO2 cylinder

Press the blue operation button until all excess pressure is released

Loosen the nut on the CO2 cylinder and remove the CO2 cylinder

Replace with full CO2 cylinder

Place steel wire for connection hose around the CO2 tank

Add rubber seal rings to inside of connection hose nut, then connect to CO2 tank

Tighten using hands, then use a wrench to tighten it.

NOTE: do not overtighten

Slowly open CO2 tank, ensuring no leaks in the system, then fully open CO2 tank

Press the blue operation button to ensure functionality

Troubleshooting:

Issue

Not producing a full block of dry ice

Dry Ice is not dense or full

Not producing dry ice at all

Remedy

Replace the CO2 tank with a full tank

Confirm unit is plugged in to appropriate outlet and breaker is not tripped

- 2 -