CORNING Centrix Jumper-Routing - Seite 4

Blättern Sie online oder laden Sie pdf Jumper-Routing für Netzwerk-Hardware CORNING Centrix herunter. CORNING Centrix 20 Seiten. System splitter/cwdm cassette installation
Auch für CORNING Centrix: Anleitung Handbuch (8 seiten), Schnellstart-Handbuch (2 seiten)

Seite drucken

1. Connect Jumpers

WARNING: Never look directly into the end of a fiber that may be

carrying laser light. Laser light can be invisible and can damage your

eyes. Viewing it directly does not cause pain. The iris of the eye will

not close involuntarily as when viewing a bright light. Consequently,

serious damage to the retina of the eye is possible. Should accidental

eye exposure to laser light be suspected, arrange for an eye

examination immediately.

• Make the connections in the first cassette as described in this section.

• Then route the jumpers as described in

• Lastly, make the connections in the second cassette following the

instructions in this section.

Step 1: If routing jumpers to an adjacent frame, start with the most densely

loaded frame (source frame). Pull module out to detent position

(Figure

TPA-4460

Step 2: Press buttons on each side of the cassette

handle.

TPA-4461

STANDARD RECOMMENDED PROCEDURE 003-960 | ISSUE 4 | OCTObER 2017 | PAGE 2 OF 18

1).

Press

buttons

Section 2

for your application.

(Figure 2)

Figure 1

and lower the

Figure 2