CORNING Centrix 점퍼 라우팅 - 페이지 4

{카테고리_이름} CORNING Centrix에 대한 점퍼 라우팅을 온라인으로 검색하거나 PDF를 다운로드하세요. CORNING Centrix 20 페이지. System splitter/cwdm cassette installation
CORNING Centrix에 대해서도 마찬가지입니다: 사용 설명서 (8 페이지), 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄

1. Connect Jumpers

WARNING: Never look directly into the end of a fiber that may be

carrying laser light. Laser light can be invisible and can damage your

eyes. Viewing it directly does not cause pain. The iris of the eye will

not close involuntarily as when viewing a bright light. Consequently,

serious damage to the retina of the eye is possible. Should accidental

eye exposure to laser light be suspected, arrange for an eye

examination immediately.

• Make the connections in the first cassette as described in this section.

• Then route the jumpers as described in

• Lastly, make the connections in the second cassette following the

instructions in this section.

Step 1: If routing jumpers to an adjacent frame, start with the most densely

loaded frame (source frame). Pull module out to detent position

(Figure

TPA-4460

Step 2: Press buttons on each side of the cassette

handle.

TPA-4461

STANDARD RECOMMENDED PROCEDURE 003-960 | ISSUE 4 | OCTObER 2017 | PAGE 2 OF 18

1).

Press

buttons

Section 2

for your application.

(Figure 2)

Figure 1

and lower the

Figure 2